Posted by Carl-NC on 3/25/2008, 10:24 pm, in reply to "Changing coil on CZ-20"
97.89.105.109

Easy to do... Remove battery pack. There's a foam pad in the bottom of the compartment. There are 4 screws under the corners of the pad. You can probably get to them by lifting only the corners. Remove the 4 screws. Loosen the cable seal. The case will now split apart, you will need to push some of the cable into the case to get enough slack. Unsolder the coil cable, noting the wire locations. Remove the old coil. Install the new coil, you can reuse the seal. Reassemble the case, carefully take out the cable slack, tighten seal. - Carl