Posted by Paul on 9/29/2002, 7:36 pm
65.117.176.89
Hi All, Being a retired mold&Die maker and draftsman I knew I could fix this problem I was having with my Treasure Baron. The problem was that I couldnt install the deephunter in the back of the tb because it wouldnt go in far enough.Well no.1 rule is (Dont use force,,,,Get a bigger Hammer)Now I didnt think that would work so I took the TB apart and could see that the coin trax was against the speaker and looked like the deep hunter was going all the way up against the speaker.So I took the glue off the speaker and still when I would slide the coin trax in then it would push the deep hunter out on the back???? I then took the speaker out and compared it to some speakers I had out in the garage.I then found one speaker that was almost 1/32" thinner???I then put the thinner speaker in and everything fit. So if you are having problem with the deep hunter going all the way in...It might be the speaker. I have had my TB 2 different ways.1 I had the batteries under my arm rest and the Main TB being like it is. The weight of the batteries were under my arm but then I wanted it with the complete Baron mother board with batteries and deep hunter under the arm rest and The Coin trax or pro hunter on top of the handle. The wire that plugs in the coin trax to the mother board is a 26 pin.The same as a printer connector inside your puter(IF your wife comes home and the printer dosent work...better think Fast)anyhow this idea seems to be the best set-up..But my proto type is kind of rough.I used a set of license plates that I bent the way I wanted them.By The way the case of the TB(Black Box is 1lb and6oz)with nothing in it! Compare that to a set of license plates that weighs at 4ozs..... This was just a test and I liked the way it all worked but put it all back in the TB box untill I can make a better box when I have the time...But right now I have to go and beat my wife at finding the best targets!! Paul